Differences

This shows you the differences between two versions of the page.

--- tech:sugablureplacesim [2024/08/19 17:06] – admin
+++ tech:sugablureplacesim [2024/08/20 07:26] (current) – admin
@@ Line 28: / Line 28: @@
 ===Open the baton===
 The baton has been designed to be replaced once opened. However if you do not have access to a new casing you can open the baton carefully and temporarily use the same baton casing when finished. Gently use a plumbing pliers to squeeze the baton near the front where it is attached and break the glue by gently squeezing and turning.
+{{:tech:sbopen1.jpeg?direct&400|}}{{:tech:sbopen2.jpeg?direct&400|}}{{:tech:sbopn4.jpeg?direct&400|}}
 ===Take out the board===
@@ Line 33: / Line 34: @@
 ===Replace the SIM card===
-Remove the glue from the SIM card. Do not lift the SIM card off the board as the holder will be damaged. Once the glue has been removed pushing the SIM card in will take it out. A new SIM card can be pushed in place of the old one.
+Remove the glue from the SIM card. Do not lift the SIM card off the board as the holder will be damaged. Once the glue has been removed the SIM card by sliding it out. A new SIM card can be pushed in place of the old one.
+{{:tech:sbsim.jpeg?direct&400|}}{{:tech:sbsim2.jpeg?direct&400|}}
 ===Place the board in a casing===
 Place the board back in a casing. Ensure the board slides along the rails made for it. The LED at the back should be facing the keying.
+{{:tech:sborintation.jpeg?direct&400|}}
 ===Set the APN of the SIM card===